Here is the connection diagram (again, by hand) and the final iteration of the code.
Later edit:
This is the final look after some work on a test PCB. I let the USB port accesible for future development:
20 martie 2017
Kenwood AT-300 ATU to ICOM Radio - II
In a previous post I wrote about a devil plan to connect a Kenwood AT-300 Automatic antenna tuner to an ICOM 7300 radio.
Here is the connection diagram (again, by hand) and the final iteration of the code.
Later edit:
This is the final look after some work on a test PCB. I let the USB port accesible for future development:
Here is the connection diagram (again, by hand) and the final iteration of the code.
Later edit:
This is the final look after some work on a test PCB. I let the USB port accesible for future development:
Dear Dan, I am going to build this great project to connect mt Kenwood AT50 to my IC703! Just need to know how to upload this program into the arduino. It is not written in the Arduino language . Many thanks for your help ! Leon on4lkc
RăspundețiȘtergereHi Leon,
RăspundețiȘtergereIt's written in C for Arduino IDE so it is full compatible!
73 de Adrian
RăspundețiȘtergereHi Dan, I hope you are all well.
I would like to thank you for your work to carry out this project. This weekend I hope to try it. I'll tell you.
A greeting.
EA1FEZ, Agustin
RăspundețiȘtergereHi Dan, I hope you are all well.
I would like to thank you for your work to carry out this project. This weekend I hope to try it. I'll tell you.
A greeting.
EA1FEZ, Agustin
Acest comentariu a fost eliminat de autor.
RăspundețiȘtergere