06 iulie 2021

Xiegu G90 Block Diagram and Schematic

Based on work of Bob, W9RAN and some modest contribution from my side, here is the block diagram of the popular Xiegu G90 transceiver.


 

 

THIS PART IS NO LONGER ACTUAL BECAUSE THE FULL SCHEMATICS ARE AVAILABLE

 

And, based on reverse engineering of parts I am interested in, here is the schematic. Attention, it is work in progress!

Last version: September 15, 2021 - minor corrections



I received a very interesting e-mail from Nils, W8IJN. 
Many thanks Nils for the informations:

Adrian,

I've been following your adventures exploring the inner workings of the G90. I've downloaded all the schematic diagrams that you've put together about the radio.

Recently I blew up the two 100 Ohm resistors in the area around the key jack. I sent Radioddity a note and they responded with a schematic of that area. The drawing is included with this email to add to your collection.

The problem came from testing a EFHW antenna with the 49:1 balun sitting a meter from the radio and connected by what turned out to be a faulty cable. The radio wasn't grounded and the key line did not have any RF suppression/chokes on it. I figure the RF got past the RFC and the zener diodes shorted the RF through the 100 Ohm resistors to ground.

I repaired this with parts I had and added 1nf caps on the high/key jack side of the RFCs. We'll see how that works out. Oh, and I grounded the radio and put a clip-on ferrite on the key line.

Stay safe and well, Adrian. We will survive!




73

Nils R. B. Young
W8IJN

There is a small difference between the schematic received from Xiegu and what i found on my board. The supressing capacitors in my radio are between the resistors and inductors while in the picture sent by Xiegu are on the ESD suppressing diodes. This might be from a different revision or even a mistake in my drawing. I will check this soon.

Niciun comentariu:

Most viewed posts in last 30 days