2. Default relay output on NodeMCU is GPIO 12 on ESP8266 (D6) on LoLin NodeMCU clone).3. In the photo attached is NodeMCU LoLin clone pinout description.
4. Prepare RaspberryPi for DOMOTICZ.
07 februarie 2019
ESP8266 NodeMCU LoLin - Sonoff Emulator
1. Install Sonoff-Tasmota firmware following the instructions here.
2. Default relay output on NodeMCU is GPIO 12 on ESP8266 (D6) on LoLin NodeMCU clone).
3. In the photo attached is NodeMCU LoLin clone pinout description.
4. Prepare RaspberryPi for DOMOTICZ.
2. Default relay output on NodeMCU is GPIO 12 on ESP8266 (D6) on LoLin NodeMCU clone).3. In the photo attached is NodeMCU LoLin clone pinout description.
4. Prepare RaspberryPi for DOMOTICZ.
Abonați-vă la:
Postări (Atom)
Most viewed posts in last 30 days
-
Icom IC-7300 wide band modification by PA2DB: Remove bottom and find the diode matrix (near big chip) Open RX 0.030-74.8Mhz (REMOVE D... -
Kenwood Programing Software FIRMWARE: KDS-100 504XXXXX 4A46 PTT ID Display feature 176.86 KB CURRENT 401XXXXX F7FC Corrects lock up whe...
-
Icom programming Software GM-110SC rev.1.2. ex1725. IC-3FX 245MHZ THAILAND CB HANDY RADIO, EX2020 REV 1.0. IC-3FGX 80 CHANNELS 245MHZ THAILA...