I just received a few days ago my Easypic Fusion 7 board with a PIC24 microcontroller. It's just beautiful!
Well, it's a giant step from PIC16F but my friend and mentor said that it's just no reason to continue to learn about microcontrollers on an old one. So, I follow his words and jumped to 24 and DSPic... First, PIC24.
This is my first piece of program written in C, reading the value from the ADC, translated from binary to decimal and then sent it to the TFT display.
Here I found the knowledge.
Abonați-vă la:
Postare comentarii (Atom)
Most viewed posts in last 30 days
-
Icom IC-7300 wide band modification by PA2DB: Remove bottom and find the diode matrix (near big chip) Open RX 0.030-74.8Mhz (REMOVE D...
-
Kenwood Programing Software FIRMWARE: KDS-100 504XXXXX 4A46 PTT ID Display feature 176.86 KB CURRENT 401XXXXX F7FC Corrects lock up whe...
-
Icom programming Software GM-110SC rev.1.2. ex1725. IC-3FX 245MHZ THAILAND CB HANDY RADIO, EX2020 REV 1.0. IC-3FGX 80 CHANNELS 245MHZ THAILA...
Niciun comentariu:
Trimiteți un comentariu