A few days ago I noticed that, while trying to work on 40m from mobile, my Icom IC-7000 suddenly stops, powering off.
So, investigating the trouble I put a (very) Ugly Balun at the output of the radio.
The problems went off so I planed to make some sort of Choke balun.
This broadband transformer is a 1:1 and block the current mode current.
Here it is the making off:
LE:
The main reason for making it with two RF connectors is that the choke is used in mobile installation and after it there is a small lenght of coaxial cable.
73 de YO3HJV
Abonați-vă la:
Postare comentarii (Atom)
Most viewed posts in last 30 days
-
Kenwood Programing Software FIRMWARE: KDS-100 504XXXXX 4A46 PTT ID Display feature 176.86 KB CURRENT 401XXXXX F7FC Corrects lock up whe...
-
Icom programming Software GM-110SC rev.1.2. ex1725. IC-3FX 245MHZ THAILAND CB HANDY RADIO, EX2020 REV 1.0. IC-3FGX 80 CHANNELS 245MHZ THAILA...
-
Icom IC-7300 wide band modification by PA2DB: Remove bottom and find the diode matrix (near big chip) Open RX 0.030-74.8Mhz (REMOVE D...
2 comentarii:
E bum acest chock - si eu am unul din 2012 ptr ca la antena undita din portabil se intorcea cam mult RF in 40 si 80 m si nu mai iesea din emisie dupa ce ptt-ul era off. Cu el totul este ok. ... Numai bine , Dan yo3gh
Si e pus langa TRX sau langa antena?
Trimiteți un comentariu