Here is the connection diagram (again, by hand) and the final iteration of the code.
Later edit:
This is the final look after some work on a test PCB. I let the USB port accesible for future development:
Showing posts with label at-300. Show all posts
Showing posts with label at-300. Show all posts
20 March 2017
Kenwood AT-300 ATU to ICOM Radio - II
In a previous post I wrote about a devil plan to connect a Kenwood AT-300 Automatic antenna tuner to an ICOM 7300 radio.
Here is the connection diagram (again, by hand) and the final iteration of the code.
Later edit:
This is the final look after some work on a test PCB. I let the USB port accesible for future development:
Here is the connection diagram (again, by hand) and the final iteration of the code.
Later edit:
This is the final look after some work on a test PCB. I let the USB port accesible for future development:
Subscribe to:
Comments (Atom)
Most viewed posts in last 30 days
-
Kenwood Programing Software FIRMWARE: KDS-100 504XXXXX 4A46 PTT ID Display feature 176.86 KB CURRENT 401XXXXX F7FC Corrects lock up whe...
-
Finally, the schematic of Xiegu G90 is available! Here they are, in pdf format. 1 PA RF Board 2 Small Signal Board 3 Display Unit 4 Microph...
-
Icom IC-7300 wide band modification by PA2DB: Remove bottom and find the diode matrix (near big chip) Open RX 0.030-74.8Mhz (REMOVE D...